The Installation of a New Washing Machine

Trouble Levels

• Medium - a fairly simple and easy project

Estimated time for you to complete

• Have  at least an hour

Degree of Danger

• Low - however need to make sure the water supply and electric source are put off

Learn how to achieve it (In Simple simple steps)

1. Shut down water supply and the source of electricity

2. Look into the length of the cable

Prior to starting it's essential to guarantee the machine’s cable will reach the wall socket. If it doesn’t you need to contact an electrical contractor to either move the plug socket - adding a lot of extra time and cash on the job.

3. Check out the pipe line will reach

Much like preceding you have to make certain the drain hose the outlet water line which drains the water from the is going to get to the waste tube (the tube within kitchen sink which leads to the drain pipes) If it doesn't you have got to get hold of another one  the producer.

4. Install this drain hose to the appliance

Working with a hose clamp (you can purchase virtually all DIY shops) fix on the actual drain hose to the device. It's a fitting which will secure the drain line in its place at the rear of the appliance

5 Install the water hoses to the unit

Affix water tubes in the rear of the appliance (both lengthy hoses, ordinarily one red-colored one blue) to the stop valves beneath the sink through screwing these into location. The red-colored hose runs to the valve underneath the hot tap, the blue will go to valve underneath the cold tap Red means hot blue shows cold.

6. Push the equipment into location

Plug the automatic washer in, and shift it location inserting the drain hose inside the drainpipe when you are able achieve it pushing the actual washer the rest of the way into the area, being watchful not to crimp the tubes.

Be sure you leave about an inch and a half of space around the washer to permit room for this in order to vibrate.

7. Turn the water supply on.

8. Turn the electrical energy back on at the mains

9. Check the equipment

With no having any kind of apparel or washing powder in the equipment, turn it on and let it run the complete cycle to check the drainage and to water lines.